-273-p.jpg?v=2972020-115048)
-273-p.jpg?v=2972020-115048)
-273-p.jpg?v=2972020-115048)
-273-p.jpg?v=2972020-115048)
Auto or Manual JT500 (Gi) grey water pump (7m lift) replacement for the telka
£285.99
Inc Tax £343.19
This Telka 44 / Ego Gi pump is designed for handling clean, dirty or slightly polluted water. Integral float switch, 10 metres cable, Stainless steel motor casing, Non-rusting materials
You will earn 343 points with this purchase
Auto or Manual JT500 Gi (Replacement for the Telka 44 Gi ) is designed for handling clean, dirty or slightly polluted water. Integral float switch, 10 metres cable, Stainless steel motor casing, Non-rusting materials.
These 240/1/50 pumps are designed for handling clean, dirty or slightly polluted water. They feature an integral float switch, making them particularly useful for tight sump and restricted access applications.
At the flick of a switch, these models can be locked into either automatic or manual operation. In automatic mode the pump will start at approx. 115mm and pump down to a level of approx. 55mm. On manual, the pump will pump down to 9mm, but should not be left unattended to run dry.
• Built-in thermal protection with auto reset
• Suitable for continuous duty up to 35°C
• Open impeller for 9mm soft solids passage
• 10m H07RN-F cable and plug as standard
• Supplied with non-return valve and variable hosetail as standard.
Materials
The JT500 is designed for heavy duty applications using antioxidant and corrosion resistant materials.
Pump casing, body and impeller in PPS (Polyphenylene Sulphide)
Stainless steel motor casing/shaft.
Special wear resistant shaft coating.
Special triple shaft seal.
Comes with Variable dia. Hosetails with build in non-return valve
These 240/1/50 pumps are designed for handling clean, dirty or slightly polluted water. They feature an integral float switch, making them particularly useful for tight sump and restricted access applications.
At the flick of a switch, these models can be locked into either automatic or manual operation. In automatic mode the pump will start at approx. 115mm and pump down to a level of approx. 55mm. On manual, the pump will pump down to 9mm, but should not be left unattended to run dry.
• Built-in thermal protection with auto reset
• Suitable for continuous duty up to 35°C
• Open impeller for 9mm soft solids passage
• 10m H07RN-F cable and plug as standard
• Supplied with non-return valve and variable hosetail as standard.
Materials
The JT500 is designed for heavy duty applications using antioxidant and corrosion resistant materials.
Pump casing, body and impeller in PPS (Polyphenylene Sulphide)
Stainless steel motor casing/shaft.
Special wear resistant shaft coating.
Special triple shaft seal.
Comes with Variable dia. Hosetails with build in non-return valve
| Brand | JTPumps |
| Weight | 5kg |
| MPN | EGO500GI |
You may also like
-
JT High Water Alarm / Battery Backup with Volt free Contacts
£399.99JT High Water Alarm / Battery Backup with Volt free Contacts & Conventional float 5m PVC cable & Counterweight This Simple to install unit is designed for audible / visual alarm of pump plant failure, even in the case of power cut. It features a 102dB/1m alarm with a battery back-up time of approximately 12 hours.